- Sealed ram-type, full oil displacement hydraulic cylinders with hard chrome plated and polished stress-proof steel rams and polyurethane seals. Positive internal stops
- Safety velocity fuse at base of each cylinder to prevent descent in the event of loss of hydraulic pressure
- NEMA 4, 13 (water tight, oil tight and dust tight) adjustable upper travel limit switch automatically shuts off the motor and pump at the raised-height setting
- Four secondary mechanical upper travel back-up stops, 2 mounted on platform understructure and 2 mounted on base, restrict the scissor arms from moving beyond the preset travel
- Axles and shafts are stressproof shafting, hard chrome plated and polished, retained with a positive-locking screw ring system and equipped with lifetime lubricated bearings
- All axle and roller bearings are PTFE lined, composite type and have the qualities of good wear resistance and heat conductivity, high strength, low thermal resistance and low friction
- Hydraulic hose, SAE 100 R2AT, double wire braid from cylinders to universal connection on base frame. Hose from lift to power unit is not included
- Aluminum valve block manifold contains check valve, relief valve, pressure-compensated flow control valve and solenoid valve. The solenoid valve includes a filter screen
- NEMA-12 prewired control box (dust/drip-tight industrial type) with liquid-tight electrical connectors. Control box contains magnetic starter, control transformer, thermal overload and fuses, mounted on the oil reservoir
- High-pressure gear pump
|
- Safety tread steel plate platform with 8 in. beveled toeguards and black and yellow safety stripes
- Steel safety tread bridge plate, 18 x 72 in., with 2 safety chains
- Two removable steel handrails 42 in. high with midrail
- Four safety chains with snap hooks
- Rectangular, structural tube scissor legs and torque tubes
- Positive stops on all four corners for maximum roll-over capacity in lowered position
- Hinged safety restraint maintenance bars
- Surfaces degreased, oxide primed and finished with two coats of enamel
- External power unit is prewired, factory tested and assembled
- 5HP, 230/460V, 3PH, 60Hz continuous duty TEFC motor
- 11 gal. reservoir, oil not included
- Pressure line 25-micron cartridge filter
- Liquid tight strain relief type electrical cord connectors
- NEMA-4X constant-pressure (water-tight, dust-tight and corrosion-resistant) "UP-DOWN" pushbutton control with 20 ft. coiled cord and hanger bracket
- 24V operating control voltage
- All controller components are UL and/or CSA approved
|